THERMADOR Error Code E13 – How to fix? by ApplianceRepairNewYork.us
THERMADOR Error Code E13
Professional Ranges Models: PDR30/36/48…PRG30/36/48
| ERROR CODE | DESCRIPTION | RESOLUTION |
| CODE E13 | Turns heat off on failed oven only, micro not affected. Disables clean mode in both ovens, allows cook and microwave. Turns heat off on failed oven only, micro not affected. | CT ovens; latch froze or no power to latch motor CMT ovens; control board not converted |
| ERROR MESSAGE | ERROR CODE NOTES | DESCRIPTION OF PROBLEM |
| E1 | C&E | Control board problem. |
| E2 | G&K | Cook or Clean mode runaway (temp >635 °F) Clean mode runaway (clean temp +32 °F). |
| E3 | A&H | Open oven temperature sensor (>5000 Ω). |
| E4 | A&H | Shorted oven temperature sensor (<5000 Ω). |
| E5 | K&D | Control board too cold, too hot, or defective. |
| E6 | C&J | Control board problem. |
| E7 | A&I | Illegal temperature display. Turn off oven and try again. |
| E8 | A&D | Control board problem. |
| E9 | A&E | Latch switch problem. |
| E10 | B&D | Control board problem. |
| E11 | A&F | CT oven – latch switch problem |
| E12 | A&E | CT ovens – latch switch problem |
| E13 | A&C | CT ovens – latch frozen or no power to latch motor. CMT ovens – control board not converted (refer to page 3-7 for conversion data). |
| E14 | A&E | Latch switch problem. |
| E15 | B&D | Control board problem. |
| ERROR CODE NOTES | DESCRIPTION OF PROBLEM |
| A | Turns heat off on the failed oven only; microwave not affected. |
| B | Turns all heat off; microwave not affected. |
| C | Disables the CLEAN mode in both ovens; allows COOK and microwave. |
| D | Error will remain in the display until oven is repaired and powered back up. No error tones. |
| E | Turning the oven off stops the error and flashing display. Can tweak away the error code. Error is redisplayed only if the selector is turned to CLEAN. |
| F | Tweaking clears to “—“ for retry. |
| G | Clears when the oven temperature is less then the runaway temperature with the selector switch off. |
| H | Can be cancelled by tweaking if a good sensor is detected. |
| I | Cleared with a mode change. |
| J | Can be tweaked away for immediate retry. User must unlatch and delete the “—“ to try to relatch the door. |
| K | Turns heat and microwave off. |
| L | If two switches show a locked door, then E13 and LOCK are permanent in the display (in all modes). If the two switches show an open door, tweak away the E13 error message. |